INVT Inverter Goodrive 800 Series Manual

The INVT Goodrive 800 Series is a high-performance inverter designed for various industrial applications. It features advanced control algorithms, a user-friendly interface, and robust protection mechanisms. This manual provides essential information on safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Inverter 8. Maintenance 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: High-performance control algorithms, user-friendly interface, multiple communication protocols, and comprehensive protection features.

Feature	Description
Advanced Control	Supports V/F control, vector control, and servo control modes.
User Interface	Intuitive keypad with LCD display for easy operation.
Communication	Supports RS485, CANopen, and Modbus protocols.
Protection Features	Over-voltage, under-voltage, over-current, and thermal protection.
Energy Efficiency	High efficiency ratings to reduce energy consumption.

Installation

Ensure proper installation to maximize performance and safety.

Mount the inverter securely in a well-ventilated area.
Connect the power supply and ensure proper grounding.
Connect the motor and other devices as per the wiring diagram.
Power on the inverter and check for proper operation.

WARNING! Follow all safety guidelines to prevent electrical hazards.

First-Time Setup

Configure the inverter settings for optimal performance.

Power on the inverter and access the setup menu.
Select the motor parameters and input voltage settings.
Adjust the control mode according to the application requirements.
Save the settings and exit the setup menu.

CAUTION! Ensure all connections are secure before powering on.

Specifications

Input Voltage: 220V/380V AC.
Output Power: Up to 15kW.
Control Modes: V/F, vector control, servo control.
Communication: RS485, CANopen, Modbus.
Protection Class: IP20.
Operating Temperature: -10°C to 50°C.

Controls and Settings

Access the inverter settings via the keypad or remote interface.

Keypad: POWER, UP, DOWN, ENTER, ESC.

Settings include motor parameters, control mode, and communication settings.

Connecting Devices

Ensure proper connections for optimal performance.

Turn off the inverter before connecting devices.
Match cables to the appropriate terminals.
Power on the inverter and check for correct operation.

Tip: Always refer to the wiring diagram for correct connections.

Operating the Inverter

Follow these steps to operate the inverter effectively.

Power on the inverter and ensure all settings are correct.
Select the desired operation mode.
Monitor the display for operational status and alarms.
Adjust settings as necessary during operation.

WARNING! Do not operate the inverter outside of specified limits.

Maintenance

Regular maintenance is essential for optimal performance.

Inspect connections and wiring periodically.
Clean the inverter housing to prevent dust accumulation.
Check for any signs of wear or damage.
Update firmware as necessary for improved performance.

Regulatory Information

This inverter complies with international safety and performance standards. For more information, visit the official INVT website.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Inverter does not power on	Power supply issue	Check power connections and fuses.
Overload alarm	Excessive load on output	Reduce load and reset the inverter.
No output voltage	Incorrect settings	Verify output settings and parameters.
Communication failure	Wiring issue	Check communication cables and connections.

Reset: Refer to the manual for reset procedures.

Support: For assistance, contact INVT support.