INVT Inverter Goodrive GD35-132G-4-C1 Manual

The INVT Goodrive GD35-132G-4-C1 is a high-performance inverter designed for various industrial applications. It features advanced control algorithms, robust design, and user-friendly interfaces. This manual provides essential information regarding safety, features, installation, setup, operation, and troubleshooting of the inverter.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Inverter 8. Maintenance 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: High-efficiency inverter, user-friendly interface, multiple control modes, built-in protection features, and communication options.

Feature	Description
High Efficiency	Optimized for energy savings and performance.
User Interface	Intuitive display for easy operation and monitoring.
Multiple Control Modes	Supports V/f control, vector control, and more.
Built-in Protection	Over-voltage, under-voltage, over-current protections.
Communication Options	Supports Modbus, CANopen for integration.

Installation

Ensure proper installation for optimal performance. Follow the guidelines below.

Mount the inverter securely in a well-ventilated area.
Connect the input power supply according to the wiring diagram.
Ensure all connections are tight and secure.
Connect the output to the motor or load.

WARNING! Ensure power is off during installation to avoid electric shock.

First-Time Setup

Power on the inverter and follow the setup wizard on the display.

Select the motor type and parameters.
Set the operational mode (e.g., V/f control).
Configure communication settings if applicable.
Save the settings and exit the setup menu.

CAUTION! Double-check all settings before starting the inverter.

Specifications

Input Voltage: 380V-480V AC.
Output Power: Up to 132 kW.
Control Mode: V/f control, vector control.
Protection Class: IP20.
Operating Temperature: -10°C to 50°C.
Weight: Approximately 30 kg.

Controls and Settings

Access settings through the user interface. Key controls include:

Display: Shows operational status and parameters.

Buttons: Navigate through menus and settings.

Adjust parameters such as frequency, voltage, and motor settings as needed.

Connecting Devices

Follow these steps to connect devices to the inverter:

Ensure the inverter is powered off before making connections.
Connect the motor to the output terminals.
Connect the control panel if applicable.
Power on the inverter and check connections.

Tip: Always refer to the wiring diagram provided in the manual.

Operating the Inverter

To operate the inverter, follow these steps:

Power on the inverter using the main switch.
Select the desired operational mode.
Start the motor using the start command.
Monitor the performance through the display.

WARNING! Do not exceed the rated parameters during operation.

Maintenance

Regular maintenance is essential for optimal performance:

Check connections and tighten if necessary.
Clean the inverter casing and ensure ventilation is unobstructed.
Inspect for any signs of wear or damage.

Regulatory Information

This inverter complies with international safety and performance standards. For more information, refer to the certification documents.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Inverter does not start	Power supply issue	Check input power connections.
No output voltage	Faulty connections	Inspect output wiring.
Overheating	Poor ventilation	Ensure adequate airflow around the inverter.
Error codes displayed	Faulty components	Refer to the error code section in the manual.

Reset: Follow the reset procedure in the user interface if necessary.

Service: For support, contact INVT customer service.