INVT Inverter Goodrive GD35-132G-6-D1 Manual

The INVT Goodrive GD35-132G-6-D1 is a high-performance inverter designed for various industrial applications. It features advanced control algorithms, robust protection mechanisms, and a user-friendly interface. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Inverter 8. Maintenance 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: High-efficiency inverter, user-friendly interface, multiple communication protocols, and extensive protection features.

Feature	Description
High Efficiency	Optimized for energy savings and performance.
Multiple Control Modes	Supports V/f control, vector control, and more.
Built-in Protection	Over-voltage, under-voltage, over-current, and thermal protection.
Communication Protocols	Supports Modbus, CANopen, and other protocols.
User Interface	Intuitive LCD display for easy monitoring and configuration.

Installation

Ensure proper installation to maximize performance and safety.

Mount the inverter securely in a well-ventilated area.
Connect the input power supply according to the wiring diagram.
Connect the output to the motor or load.
Ensure all connections are tight and secure.

WARNING! Follow all safety guidelines to prevent electrical hazards.

First-Time Setup

Power on the inverter and follow the setup wizard on the display.

Select the appropriate control mode for your application.
Set the motor parameters as per the specifications.
Configure communication settings if applicable.
Save the settings and perform a test run.

CAUTION! Ensure all settings are correct before operating the inverter.

Specifications

Input Voltage: 380-480V AC.
Output Power: Up to 132 kW.
Control Modes: V/f control, vector control.
Protection Class: IP20.
Operating Temperature: -10°C to 50°C.

Controls and Settings

Access settings via the LCD display or through external communication.

Key Controls: Power, Start/Stop, Parameter settings, and Fault reset.

Adjustable parameters include frequency, acceleration, deceleration, and motor settings.

Connecting Devices

Ensure proper connections to avoid damage to the inverter or connected devices.

Turn off power before making connections.
Follow the wiring diagram for input and output connections.
Verify all connections before powering on the inverter.

Tip: Use appropriate gauge wiring for your application.

Operating the Inverter

Follow the operational guidelines for optimal performance.

Power on the inverter and select the desired mode.
Monitor the display for any fault indications.
Adjust settings as necessary during operation.
Perform regular checks on the inverter's performance.

WARNING! Do not operate the inverter outside of specified limits.

Maintenance

Regular maintenance is essential for longevity and performance.

Inspect connections and wiring periodically.
Clean the inverter casing and ensure ventilation is unobstructed.
Check for any signs of wear or damage.
Update firmware as necessary.

Regulatory Information

Complies with international safety and performance standards. For support, visit www.invt.com or contact customer service.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Inverter does not power on	Power supply issue	Check input voltage and connections.
Overheating	Insufficient ventilation	Ensure proper airflow around the inverter.
Fault indication on display	Configuration error	Refer to the manual for fault codes and corrective actions.
Motor not running	Incorrect settings	Verify motor parameters and settings.

Reset: Follow the reset procedure in the manual if necessary.

Service: For technical support, contact INVT customer service.