INVT Inverter Goodrive GD35-160G-4-S1 Manual

The INVT Goodrive GD35-160G-4-S1 is a high-performance inverter designed for various applications, including industrial automation, HVAC systems, and renewable energy. It features advanced control algorithms, high efficiency, and robust protection mechanisms. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Inverter 8. Maintenance 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: High-performance control algorithms, multiple protection features, user-friendly interface, and compact design.

Feature	Description
Advanced Control	Supports vector control and V/F control for various applications.
Protection Mechanisms	Over-voltage, under-voltage, over-current, and thermal protection.
User Interface	Easy-to-read display and intuitive controls for user convenience.
Compact Design	Space-saving design suitable for various installations.
Communication Options	Supports Modbus, CANopen, and other communication protocols.

Installation

Ensure proper installation for optimal performance. Follow the guidelines below.

Mount the inverter securely in a well-ventilated area.
Connect the power supply and ensure proper grounding.
Connect the motor and control wiring as per the wiring diagram.
Power on the inverter and check for proper operation.

WARNING! Ensure all connections are secure to prevent electrical hazards.

First-Time Setup

Power on the inverter and follow the on-screen prompts to configure settings.

Select the motor type and parameters.
Set the operating frequency and voltage.
Configure protection settings as needed.
Save the settings and perform a test run.

CAUTION! Ensure all settings are correct before operating the motor.

Specifications

Model: GD35-160G-4-S1.
Input Voltage: 380V-480V AC.
Output Power: 160 kW.
Operating Temperature: -10°C to 50°C.
Protection Class: IP20.
Communication Protocols: Modbus, CANopen.

Controls and Settings

Access settings via the user interface. Key controls include:

Display: Shows operating status and parameters.

Buttons: Navigate through menus and adjust settings.

Settings include motor parameters, protection settings, and communication options.

Connecting Devices

Ensure proper connections for optimal performance.

Turn off the inverter and all connected devices before making connections.
Connect the motor and control wiring according to the wiring diagram.
Ensure all connections are secure and insulated.

Tip: Double-check all connections before powering on the inverter.

Operating the Inverter

Follow these steps to operate the inverter:

Power on the inverter.
Select the desired operating mode.
Start the motor using the control interface.
Monitor the operating parameters on the display.

WARNING! Do not operate the inverter without proper setup and configuration.

Maintenance

Regular maintenance is essential for optimal performance.

Inspect connections and wiring regularly.
Clean the inverter casing to prevent dust accumulation.
Check for any signs of wear or damage.

Regulatory Information

This inverter complies with international safety and performance standards. For detailed information, refer to the certification documents.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Inverter does not power on	Power supply issue	Check power connections and supply voltage.
Overheating	Poor ventilation	Ensure adequate airflow around the inverter.
No output to motor	Incorrect wiring	Verify wiring connections and settings.
Fault code displayed	Internal error	Refer to the manual for fault code definitions.

Reset: Follow the reset procedure in the user manual if necessary.

Service: Contact INVT support for assistance.