INVT Inverter Goodrive GD35-200G-4-C1 Manual

The INVT Goodrive GD35-200G-4-C1 is a high-performance inverter designed for various applications, providing reliable control of AC motors. It features advanced control algorithms, a user-friendly interface, and robust protection mechanisms. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Inverter 8. Maintenance 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: Advanced control algorithms, user-friendly interface, multiple protection features, compact design, and high efficiency.

Feature	Description
Advanced Control	Supports V/F control, vector control, and torque control.
User Interface	Easy-to-read display with intuitive navigation.
Protection Features	Over-voltage, under-voltage, over-current, and over-temperature protection.
Compact Design	Space-saving design suitable for various installations.
High Efficiency	Optimized for energy savings and reduced operational costs.

Installation

Ensure proper installation for optimal performance. Follow these steps:

Mount the inverter securely in a well-ventilated area.
Connect the input power supply according to the wiring diagram.
Connect the output to the motor ensuring correct phase alignment.
Ground the inverter properly to prevent electrical hazards.

WARNING! Ensure all connections are secure and follow local electrical codes.

First-Time Setup

Power on the inverter and follow the setup wizard on the display.

Select the motor type and parameters.
Set the operational modes (e.g., speed control, torque control).
Configure safety settings and alarms.
Save the settings and perform a test run.

CAUTION! Ensure all safety measures are in place before operating.

Specifications

Input Voltage: 380V AC ± 15%.
Output Voltage: 0-380V AC.
Power Range: 0.75 kW to 200 kW.
Control Mode: V/F control, vector control.
Operating Temperature: -10°C to 50°C.
Protection Class: IP20.

Controls and Settings

Access settings via the user interface. Key controls include:

Display: Shows operational status and parameters.

Buttons: Navigate through menus, adjust settings, and start/stop operations.

Settings include motor parameters, operational modes, and safety configurations.

Connecting Devices

Follow these guidelines for connecting devices:

Ensure the inverter is powered off before making connections.
Use appropriate cables for input and output connections.
Verify all connections are tight and secure.

Tip: Double-check wiring against the provided diagrams.

Operating the Inverter

To operate the inverter:

Power on the inverter using the main switch.
Select the desired operational mode.
Start the motor using the start button.
Monitor the display for any alarms or warnings.

WARNING! Do not operate without proper training and understanding of the equipment.

Maintenance

Regular maintenance is essential for optimal performance:

Inspect connections and wiring periodically.
Clean the inverter casing to prevent dust accumulation.
Check for any signs of wear or damage.
Ensure proper ventilation around the inverter.

CAUTION! Always disconnect power before performing maintenance.

Regulatory Information

This inverter complies with international safety and performance standards. For detailed compliance information, refer to the product documentation.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Inverter does not power on	Power supply issue	Check input power connections and fuses.
Motor does not start	Incorrect settings	Verify motor parameters and operational mode.
Overheating	Poor ventilation	Ensure adequate airflow around the inverter.
Faulty display	Electrical issue	Check connections and reset the inverter.

Reset: Refer to the user interface for reset options.

Service: Contact INVT support for further assistance.