INVT Inverter Goodrive GD35-220G-4-S1 Manual

The INVT Goodrive GD35-220G-4-S1 is a high-performance inverter designed for various industrial applications. It features advanced control algorithms, high reliability, and a user-friendly interface. This manual provides essential information on safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Inverter 8. Maintenance 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: High-efficiency inverter, user-friendly interface, multiple control modes, built-in protection features, and communication options.

Feature	Description
High Efficiency	Optimized for energy savings and performance.
User Interface	Intuitive display for easy operation and monitoring.
Control Modes	Supports V/F control, vector control, and more.
Protection Features	Over-voltage, under-voltage, over-current protections.
Communication Options	Supports RS485, CAN, and other protocols.

Installation

Ensure proper installation for optimal performance. Follow the guidelines below.

Mount the inverter securely in a well-ventilated area.
Connect the input power supply according to the wiring diagram.
Ensure all connections are tight and secure.
Connect the output to the motor or load.

WARNING! Ensure the inverter is powered off during installation to avoid electric shock.

First-Time Setup

Power on the inverter and follow the setup wizard on the display.

Select the appropriate motor parameters.
Set the control mode based on your application.
Adjust the frequency and voltage settings as needed.
Save the configuration and test the operation.

CAUTION! Double-check all settings before starting the inverter.

Specifications

Input Voltage: 220V AC.
Output Power: 35kW.
Control Method: V/F control, vector control.
Protection Class: IP20.
Operating Temperature: -10°C to 50°C.
Dimensions: 300mm x 200mm x 150mm.

Controls and Settings

Access the settings via the front panel display. Use the buttons to navigate through the menu.

Key Controls: Power, Up/Down, Enter, Escape.

Settings include motor parameters, control modes, and protection settings.

Connecting Devices

Follow the steps below to connect external devices to the inverter.

Turn off the inverter before making connections.
Connect the control signals to the appropriate terminals.
Ensure proper grounding of all devices.
Power on the inverter and check for communication.

Tip: Use shielded cables for signal connections to reduce interference.

Operating the Inverter

To operate the inverter, follow these steps:

Press the power button to turn on the inverter.
Select the desired operating mode.
Start the motor by pressing the start button.
Monitor the display for any error messages.

WARNING! Do not operate the inverter without proper load connected.

Maintenance

Regular maintenance is essential for optimal performance.

Check connections and tighten if necessary.
Clean the inverter casing to prevent dust accumulation.
Inspect cooling fans for proper operation.
Update firmware as needed.

Regulatory Information

This inverter complies with international safety and performance standards. For more information, visit the manufacturer's website.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Inverter does not power on	Power supply issue	Check input power connections and fuses.
Error code displayed	Fault condition	Refer to the error code section in the manual.
Motor not running	Incorrect settings	Verify motor parameters and control mode.
Overheating	Poor ventilation	Ensure adequate airflow around the inverter.

Reset: Use the reset function in the menu if available.

Service: Contact support for further assistance.