INVT Inverter Goodrive GD35-250G-4-C1 Manual

The INVT Goodrive GD35-250G-4-C1 is a high-performance inverter designed for various industrial applications. It features advanced control algorithms, high reliability, and a user-friendly interface. This manual provides essential information regarding safety, installation, operation, and troubleshooting of the inverter.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Inverter 8. Maintenance 9. Troubleshooting

Features at a Glance

Key features include: high efficiency, compact design, multiple communication protocols, and built-in protection functions.

Feature	Description
High Efficiency	Ensures minimal energy loss during operation
Compact Design	Space-saving design suitable for various installations
Multiple Communication Protocols	Supports MODBUS, CANopen, and other protocols
Built-in Protection	Over-voltage, under-voltage, and over-temperature protection
User-Friendly Interface	Intuitive display and controls for easy operation

Installation

Ensure proper installation to maximize performance and safety.

Mount the inverter in a well-ventilated area.
Connect the input power supply to the designated terminals.
Connect the output to the motor or load.
Ensure all connections are secure and insulated.

WARNING! Follow all safety guidelines during installation to prevent electrical hazards.

First-Time Setup

Power on the inverter and configure the basic settings.

Set the motor parameters in the setup menu.
Configure the communication settings if applicable.
Test the inverter with a no-load condition before full operation.

CAUTION! Ensure all settings are correct to avoid damage to the inverter or connected equipment.

Specifications

Model: GD35-250G-4-C1
Input Voltage: 380V AC
Output Power: 250 kW
Control Method: V/F Control, Vector Control
Protection Level: IP20
Operating Temperature: -10°C to 50°C

Controls and Settings

Access the inverter settings through the control panel.

Control Panel: Includes buttons for navigation, selection, and confirmation of settings.

Settings: Adjust parameters such as frequency, acceleration, and deceleration times.

Connecting Devices

Properly connect devices to ensure optimal performance.

Ensure the inverter is powered off before making connections.
Connect the motor leads to the output terminals.
Connect any external control devices as needed.

Tip: Double-check all connections to prevent short circuits.

Operating the Inverter

Follow these steps to operate the inverter safely.

Power on the inverter using the control panel.
Select the desired operating mode.
Start the motor and monitor performance.
Adjust settings as necessary during operation.

WARNING! Do not operate the inverter beyond its rated specifications.

Maintenance

Regular maintenance is essential for longevity.

Inspect connections and wiring regularly.
Clean the inverter casing to prevent dust buildup.
Check for any signs of wear or damage.

CAUTION! Always disconnect power before performing maintenance.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Inverter does not power on	Power supply issue	Check input voltage and connections.
Error code displayed	Fault condition	Refer to the error code section in the manual.
Motor not running	Incorrect settings	Verify motor parameters and settings.
Overheating	Poor ventilation	Ensure adequate airflow around the inverter.

Reset: Use the reset function in the menu if available.

Service: For further assistance, contact INVT support.