INVT Inverter Goodrive GD35-280G-4-S1 Manual

The INVT Goodrive GD35-280G-4-S1 is a high-performance inverter designed for various industrial applications. It features advanced control algorithms, high efficiency, and robust design, making it suitable for driving AC motors in a wide range of environments. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Inverter 8. Accessibility Features 9. Care & Maintenance 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: High-performance control algorithms, user-friendly interface, multiple communication protocols, and robust protection features.

Feature	Description
High Efficiency	Optimized for energy savings and reduced operational costs.
Multiple Control Modes	Supports V/F control, vector control, and torque control.
Built-in Protection	Over-voltage, under-voltage, over-current, and over-temperature protection.
Communication Protocols	Supports Modbus, CANopen, and other industrial protocols.
User-Friendly Interface	Intuitive keypad and display for easy operation and monitoring.

Installation

Ensure proper installation to maximize performance and safety.

Mount the inverter securely in a well-ventilated area.
Connect the power supply according to the wiring diagram.
Ensure all connections are tight and secure.
Connect the motor to the inverter output terminals.

WARNING! Ensure power is off before making any connections to avoid electric shock.

First-Time Setup

Power on the inverter and follow the setup instructions on the display.

Select the motor parameters: Enter motor voltage, current, and frequency.
Set the control mode: Choose between V/F, vector, or torque control.
Configure communication settings if applicable.
Save settings and perform a test run.

CAUTION! Double-check all settings before running the motor.

Specifications

Input Voltage: 380V-480V AC.
Output Power: Up to 280kW.
Control Method: V/F, vector control.
Protection Class: IP20.
Operating Temperature: -10°C to 50°C.
Weight: Approximately 25 kg.

Controls and Settings

Access settings via the user interface on the front panel.

Keypad: Power, Run, Stop, and Parameter settings.

Monitor: Display shows operational status, fault codes, and parameter values.

Connecting Devices

Ensure proper connections for optimal performance.

Connect the motor to the inverter output terminals.
Connect the control panel and any additional devices.
Verify all connections before powering on the inverter.

Tip: Use shielded cables for communication to reduce interference.

Operating the Inverter

Follow the operational guidelines for safe and efficient use.

Power on the inverter and select the desired operation mode.
Monitor the display for any fault indications.
Adjust settings as necessary during operation.
Power off the inverter safely after use.

WARNING! Do not operate the inverter outside of specified limits.

Accessibility Features

The inverter includes features to assist users with disabilities, including clear display indicators and audible alerts for fault conditions.

Care & Maintenance

Regular maintenance is essential for optimal performance.

CAUTION! Always disconnect power before performing maintenance.

Regulatory Information

This inverter complies with international safety and performance standards. For detailed information, refer to the product certification documents.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Inverter does not power on	Power supply issue	Check power connections and fuses.
Motor does not run	Incorrect settings	Verify motor parameters and control mode.
Overheating	Poor ventilation	Ensure adequate airflow around the inverter.
Fault code displayed	System error	Refer to the manual for fault code definitions and solutions.

Reset: Follow the reset procedure in the manual if necessary.

Service: Contact INVT support for further assistance.