INVT Inverter Goodrive GD35-315G-4-C1 Manual

The INVT Goodrive GD35-315G-4-C1 is a high-performance inverter designed for various industrial applications. It features advanced control algorithms, robust protection mechanisms, and user-friendly interfaces. This manual provides essential information on safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Inverter 8. Maintenance 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: High-efficiency inverter, user-friendly interface, multiple control modes, built-in protection features, and compact design.

Feature	Description
High Efficiency	Optimized for energy savings and performance.
Multiple Control Modes	Supports V/F control, vector control, and more.
Built-in Protection	Over-voltage, under-voltage, over-current, and thermal protection.
User Interface	Intuitive display for easy monitoring and adjustments.
Compact Design	Space-saving design suitable for various installations.

Installation

Ensure proper installation for optimal performance. Follow the guidelines below:

Mount the inverter on a stable surface, ensuring adequate ventilation.
Connect the input power supply according to the wiring diagram.
Connect the output to the motor or load.
Ensure all connections are secure and insulated.

WARNING! Ensure power is off during installation to avoid electric shock.

First-Time Setup

Power on the inverter and follow the initial setup prompts.

Select the appropriate control mode based on your application.
Set the motor parameters as per the specifications.
Configure the protection settings to suit your operational environment.

CAUTION! Double-check all settings before starting the inverter.

Specifications

Model: GD35-315G-4-C1.
Input Voltage: 380V AC.
Output Power: 315 kW.
Control Mode: V/F control, vector control.
Protection Class: IP20.
Operating Temperature: -10°C to 50°C.

Controls and Settings

Access the inverter settings via the user interface. Key controls include:

Display: Shows operational status, parameters, and error codes.

Buttons: Navigate through menus and adjust settings.

Common settings include motor parameters, control mode selection, and protection settings.

Connecting Devices

Follow these steps to connect devices:

Ensure the inverter is powered off before making connections.
Connect the motor or load to the output terminals.
Connect the control signals as required by your application.

Tip: Use shielded cables for signal connections to reduce interference.

Operating the Inverter

To operate the inverter:

Power on the inverter using the main switch.
Select the desired operating mode.
Start the motor using the start command.
Monitor the operational parameters on the display.

WARNING! Do not exceed the rated specifications during operation.

Maintenance

Regular maintenance is essential for optimal performance:

Inspect connections and wiring periodically.
Clean the inverter casing to prevent dust accumulation.
Check for any signs of wear or damage.

CAUTION! Always disconnect power before performing maintenance.

Regulatory Information

This inverter complies with international safety and performance standards. For detailed regulatory information, refer to the product documentation.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Inverter does not start	Power supply issue	Check input power connections and fuses.
Error code displayed	Protection triggered	Refer to the manual for error code definitions.
Motor not running	Incorrect settings	Verify motor parameters and control settings.
Overheating	Poor ventilation	Ensure adequate airflow around the inverter.

Reset: Follow the reset procedure in the manual if necessary.

Service: For support, contact INVT customer service.