INVT Inverter Goodrive GD35-350G-6-C1 Manual

The INVT Goodrive GD35-350G-6-C1 is a high-performance inverter designed for various applications, providing reliable control of AC motors. It features advanced control algorithms, multiple communication protocols, and a user-friendly interface. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Inverter 8. Maintenance 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: Advanced control algorithms, multiple communication protocols, user-friendly interface, compact design, and high efficiency.

Feature	Description
Control Algorithms	Supports V/F control, vector control, and torque control.
Communication Protocols	Supports Modbus, CANopen, and Ethernet protocols.
User Interface	Intuitive LCD display for easy operation and monitoring.
Protection Features	Over-voltage, under-voltage, over-current, and thermal protection.
Compact Design	Space-saving design for easy installation in various environments.

Installation

Ensure proper installation for optimal performance. Follow the guidelines below.

Mount the inverter on a stable surface, ensuring adequate ventilation.
Connect the input power supply to the designated terminals.
Connect the output to the motor or load as per the specifications.
Ensure all connections are secure and insulated.

WARNING! Ensure proper grounding to avoid electrical hazards.

First-Time Setup

Power on the inverter and follow the setup instructions on the display.

Select the appropriate motor parameters using the menu.
Set the control mode (V/F, vector, etc.) as required.
Adjust the acceleration and deceleration times.
Save the settings and perform a test run.

CAUTION! Ensure all settings are correct before operating the motor.

Specifications

Input Voltage: 380V AC ± 15%.
Output Voltage: 0-380V AC.
Power Rating: 350W.
Control Mode: V/F control, vector control.
Operating Temperature: -10°C to 50°C.
Protection Class: IP20.

Controls and Settings

Access settings via the LCD display. Use the navigation buttons to adjust parameters.

Common Settings: Motor parameters, control mode, acceleration/deceleration times, and fault settings.

Connecting Devices

Ensure all devices are powered off before making connections.

Connect the motor to the inverter output terminals.
Connect the control panel if applicable.
Verify all connections are correct and secure.

Tip: Refer to the wiring diagram for proper connections.

Operating the Inverter

Follow the steps below to operate the inverter.

Power on the inverter using the main switch.
Select the desired operation mode from the menu.
Start the motor using the start button.
Monitor the operation through the LCD display.

WARNING! Do not operate the inverter without proper load connected.

Maintenance

Regular maintenance is essential for optimal performance.

Check connections and tighten if necessary.
Clean the inverter casing to prevent dust accumulation.
Inspect cooling fans for proper operation.
Perform periodic testing of settings and parameters.

Regulatory Information

This inverter complies with international safety and performance standards. For detailed information, refer to the certification documents.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Inverter does not power on	Power supply issue	Check input power connections and fuses.
Motor does not start	Incorrect settings	Verify motor parameters and control mode.
Overheating	Poor ventilation	Ensure adequate airflow around the inverter.
Fault code displayed	Internal error	Refer to the manual for fault code definitions.

Reset: Use the reset function in the menu if available.

Service: Contact INVT support for assistance.