INVT Inverter Goodrive300-19 Series Manual

The INVT Goodrive300-19 Series Inverter is designed for various applications, providing high performance and reliability. This manual covers essential information regarding installation, operation, troubleshooting, and maintenance of the inverter. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: High-efficiency inverter, user-friendly interface, multiple protection features, and communication options.

Installation

Carefully unpack the inverter and inspect for any damage. Follow the steps below for proper installation.

1. Mount the inverter: Choose a suitable location with adequate ventilation.
2. Connect the input power: Ensure correct voltage and phase connections.
3. Connect the output load: Follow the wiring diagram provided.
4. Power on the inverter: Check for proper operation and indicators.

WARNING! Ensure all connections are secure and follow electrical safety standards.

First-Time Setup

Power on the inverter and follow the on-screen prompts to configure settings.

1. Set operational parameters: Adjust voltage and frequency settings as required.
2. Configure communication settings: Set up communication protocols if needed.
3. Test operation: Verify that the inverter operates correctly under load.

CAUTION! Ensure all settings are correct before connecting to the load.

Specifications

• Input Voltage: 220V AC / 380V AC.
• Output Voltage: 220V AC.
• Power Range: 0.75kW to 15kW.
• Efficiency: Up to 98%.
• Operating Temperature: -10°C to 50°C.
• Protection Class: IP20.

Controls and Settings

Access the inverter settings via the user interface. Key controls include power on/off, parameter settings, and fault indicators.

Remote Control: Optional remote control for convenient operation.

Settings: Adjust parameters for voltage, frequency, and operational modes.

Connecting Devices

Ensure the inverter is powered off before connecting any devices.

1. Connect input power: Use appropriate cables for input connections.
2. Connect output load: Follow the wiring diagram for correct connections.
3. Power on the inverter: Verify all connections are secure before powering on.

Tip: Always double-check connections to prevent damage.

Operating the Inverter

The inverter supports various operational modes for different applications.

1. Normal Operation: Standard mode for most applications.
2. Eco Mode: Energy-saving mode for less critical loads.
3. Bypass Mode: Directly connects the load to the input power in case of inverter failure.

WARNING! Monitor the inverter during operation for any abnormal indicators.

Safety Features

The inverter is equipped with multiple safety features to protect both the unit and connected devices.

• Over-voltage protection
• Under-voltage protection
• Over-temperature protection
• Short-circuit protection

Care & Maintenance

Regular maintenance is essential for optimal performance. Follow these guidelines:

• Keep the inverter clean and free from dust.
• Inspect connections regularly for wear or damage.
• Check for any error codes and address them promptly.

CAUTION! Always disconnect power before performing maintenance.

Regulatory Information

This inverter complies with international safety and performance standards. For more information, refer to the certification documents.

Troubleshooting

Reset: Follow the reset procedure in the user interface if available.

Service: For support, contact INVT customer service.